Rotameter is a device that measures the flow rate of liquid or gas in a closed tube. It consists of a tube and float. The rotameter is standard as a result of it’s a linear scale, a relatively long measurement range, and low-pressure drop. It is very simple to install and maintain. In the construction of rotameter tube, it is marked in the division, and the reading of the meter is obtained from the scale reading at the reading edge of the float, which is taken at the largest cross-section of the float.
Working principle of Rotameter
The Rotameter’s operation is based on the variable area principle. In this principle, fluid flow raises a float in a tapered tube and increasing the area for passage of the fluid. The higher the float is maximum raised if the flow is greater. So the height of the float is directly proportional to the flow rate. With liquids, the float is raised by a combination of the buoyancy of the liquid and the velocity head of the fluid and in gases, buoyancy is negligible, and the Heat responds to the velocity head alone. The float moves up or down in the tube in proportion to the fluid flow rate and the annular area between the float and the tube wall.
A change in flow rate upsets this balance for forces. The float then moves up or down, changing the annular area until it again reaches a position where the forces are in equilibrium.
How to read a Rotameter
Set up the rotameter on a flat surface. it’s necessary for the meter to be level. Connect the gas supply through the tube to the rotameter and switch on the gas. Some rotameters keep company with customary fittings for varied size tube. Find the ball floating within the middle of the rotameter column.
How does rotameter usually get damaged
Rotameter Flowmeters area unit} devices that may measure the flowrate of liquids and gases. Generally, the rotameter could be a tube made from plastic, glass or metal combined with afloat, that responds linearly to the flow rate of the fluid therein tube.
1. The float of the rotameter does not rotate in modern designs as it used to the early ones.
2. Float shapes and proportions can be varied for different applications.